Wyotech Before Retrofit

HID Metal halide fixtures offer a great amount of light. These are a more focused spot type light. A lot of light, at great cost. Over 1000 watts per lamp.

Wyotech After Retrofit

These Two fixtures installed replace The 1000 watt HID fixtures. A greater dispersement of light over a much wider area is accomplished. 436 watts total. saving 564 watts.

Campbells Soup Supply CO. INC.

Dixon, CA.

Food Grade Environment. Replacement fixtures are 6 lamp T-8 Vaportight / Wet location fixtures (218 watts). Old fixtures (round) are HID fixtures with lenses (458 watts).

Les Schwab Tire store 400watt HID

A 400 watt HID fixture on the left. 458 watts when the ballast is included. high heat fixture

A new energy effecient fixture on the right. The 6 lamp T-8 highbay. 218 watts total. Only warm to the touch.

This is a typical HID / Metal halide fixture 458 watts

Did you know? that many times ballastst still draw 58 watts even when the lamp is burned out.

Utility companies pay you to replace these fixtures with the new energy efficient standard lighting.A customer can save half off their lighting bill.

Old Fixtures Ready for transport to Recycle.

Disposal:

TNT properly disposes of all old lighing fixtures. This alone saves the customer time and money.

New 6 lamp T-8 Highbay Flourescents W/sensors

Ready for install:

These fixtures are being prepared for install as they are staged on the scissors lift.The timers are easily set.

Occupancy sensor

The increased Savings by using sensors is impossable to calculate.

These sensors are very sensitive.

Working up to 45' high. The timer can be set for any time from 30 seconds to 20 minutes.